Impex TR-2 Bedienungshandbuch

NOTE: Please read all instructions carefully before using this product Table of Contents Safety Notice Hardware Identifier Assembly Instructi

STEP 5 (See Diagram 5) A.) Place the Seat Pad (#27) onto the Seat Support (#26). Secure it with four M6 x ¾” Hex Bolts (#6) and ؽ” Washers (#7).

STEP 6 (See Diagram 6) A.) Attach the Leg Developer (#30) to the front of Seat Support (#26). Secure it with one M10 x 3” Hex Bolt (#12), two ؾ” W

STEP 7 (See Diagram 7) A.) Insert a Foam Tube (#32) halfway through the hole on the Seat Support (#26). Insert a Foam Tube halfway through the hole

STEP 8 (See Diagram 8 & Lat Bar Cable Loop Diagram) A.) Follow the below instructions to use the Lat Bar. B.) Attach a Tech Rod Cable (#11) to

LAT BAR CABLE LOOP DIAGRAM 12

STEP 9 (See Diagram 9 & Leg Developer Cable Loop Diagram) A.) Follow the below instructions to use the Leg Developer. B.) Detach the end of the L

LEG DEVELOPER CABLE LOOP DIAGRAM 14

STEP 10 (See Diagram10 & Cable Loop Diagram) A.) Follow the below instructions when doing bench press or butterfly exercises. B.) Attach the e

TECH ROD CABLE LOOP DIAGRAM 16

EXPLODED DIAGRAM 17

WARNING LABELS PLACEMENT The Warning Labels shown here have been placed on Lower Pulley Support Base. If this Labels are missing or illegible,

TECH ROD RESISTANCE CHART TECH ROD (each side) Bench Press/ Butterfly LAT CABLE LEG DEVELOPER CABLE 5LB 5 LB 5 LB 3 LB 10LB 10 LB 10 LB 8

PARTS LIST KEY NO. DESCRIPTION Q’ty 1 Vertical Frame 1 2 Rear Support Frame 1 3 M8 x 5/8” Allen Bolt 2

IMPEX INC. LIMITED WARRANTY IMPEX Inc. ("IMPEX") warrants this product to be free from defects in workmanship and material, under normal

TABLE OF CONTENTS BEFORE YOU BEGIN... 1 IMPORTANT SAFETY NOTICE

IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a p

HARDWARE PACK 3

ASSEMBLY INSTRUCTION Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches NOTE: It is strongly recommended two or more

STEP 2 (See Diagram 2) A.) Attach the lower Rear Support Frame (#2) to the Base Platform (#8). Secure it with one M10 x 4 7/8” Hex Bolt (#13), Ø ¾”

STEP 3 (See Diagram 3) A.) Attach the High Pulley Support Bar (#18) to the Upper Frame (#17). Securely tighten with one Bracket (#19), two M10 x

STEP 4 (See Diagram 4) A.) Attach the Tech Rod Set (#24) to the Rear Support Frame (#2). Secure it with four Ø 1/4” x ¾” Philips Screws (#25). B.