Impex MD PWR-8 Bedienungsanleitung

NOTE: Please read all instructions carefully before using this product Table of Contents Safety Notice Hardware Pack Assembly Instruction Pa

STEP 4 (See Diagram 4) A.) Attach the Lat Bar Frame Bracket (#20) to the top of the Rear Vertical Frame (#7). Secure it with two M10 x 5/8” Allen

DIAGRAM 4 10

CABLE LOOP DIAGRAM 11

STEP 5 (See Diagram 5 & Cable Loop Diagram) A.) Attach the 283” Upper Cable (#48) to the swivel pulley pre-installed in the front of the Rig

DIAGRAM 5 13

STEP 6 (See Diagram 6 & Cable Loop Diagram) A.) Attach the Ball end of the 205” Lower Cable (#49) to a Pulley (#36). B.) Attach the Pulley

DIAGRAM 6 15

EXPLODED DIAGRAM 16

CAGE PARTS LIST KEY NO. DESCRIPTION Q’ty 1 Right Stabilizer 1 51 M10 x 3 ½” Carriage Bolt 2 2 Left Stabilizer 1 52 M10 x 2 3/8”

MULTI-PURPOSE BENCH HARDWARE PACK 18

TABLE OF CONTENTS BEFORE YOU BEGIN... 1 IMPORTANT SAFETY NOTI

MULTI-PURPOSE BENCH ASSEMBLY INSTRUCTION Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches. NOTE: It is strongly

STEP 2 (See Diagram 2) A.) Attach four Bushings (#26) to a Seat Support Frame (#6). B.) Attach a Backrest Support (#7) to the rear of the Seat Sup

STEP 3 (See Diagram 3) A.) Place the Backrest Board (#14) onto the Backrest Supports (#7). Secure it with four M8 x 2” Allen Bolts (#39) and ∅ 5/

STEP 4 (See Diagram 4) A.) Attach the Leg Developer (#5) to the open bracket on the Main Frame (#1). Secure it with an Axle (#17), two M10 x ¾”

STEP 5 (See Diagram 5) A.) Attach the Arm Curl Pad (#15) to the Arm Curl Stand (#4). Secure it with two M8 x 5/8” Allen Bolts (#40) and two ∅ 5/8

24

MULTI-PURPOSE BENCH PARTS LIST KEY NO. DESCRIPTION Q’ty 1 Main Frame 1 2 Front Stabilizer 1 3 Rear Stabilizer 1 4 Arm Curl Stand 1 5 Leg Develo

IMPEX INC. LIMITED WARRANTY IMPEX Inc. ("IMPEX") warrants this product to be free from defects in workmanship and material, under normal

IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a p

WARNING LABEL REPLACEMENT The warning labels shown here have been placed on the Rear Base and Upper Frame. If the labels are missing or illegible

CAGE HARDWARE PACK 4

CAGE HARDWARE PACK 5

CAGE ASSEMBLY INSTRUCTION Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches. NOTE: It is strongly recommended this

STEP 2 (See Diagram 2) A.) Attach an Upright Beam (#4) to the Right Stabilizer (#1) and the Right Support (#5). Secure the Upright Beam to the Righ

STEP 3 (See Diagram 3) A.) Attach the Rear Stabilizer (#21) to the Cross Brace (#3). Secure it with two M10 x 3 ½” Carriage Bolts (#51), one 4 ¾” x