Impex SM-3000 Bedienungshandbuch PDF herunterladen (Seite 6)

STEP 2 (See Diagram 2)

A.) Slide the Safety Stop Frame (#12) onto the Front Vertical Beam (#9) and Guide

Rod (#16) from the top. Drop the Stop Frame all the way down. Align the hole

and secure it with a Quick Release Knob (#15). Slide the Rubber Bumper (#14)

onto the Guide Rod (#16). Repeat the same procedure to install the other side.

B.) Slide the Sliding Safety Catches (#17) onto the Guide Rods (#16) from the top.

C.) NOTE: Help of another person is strongly recommended for this step. Insert the

Weight Bar (#56) through a ∅3” Thick Rubber Bumper (#54) from the left side of

the machine. Then insert the Bar through the hole on the Sliding Safety Catch

(#17). Continue inserting the Bar through the Lifting Sleeve (#53).

D.) Insert the Bar through the Sliding Safety Catch (#17) on the right side. Place

another ∅ 3” Thick Rubber Bumper (#54) onto the Bar. Make sure the gap on

both side of the bar is even. Secure the M8 x 1/2” Bolts (#55) on the Sliding

Safety Catches (#17).

E.) Install a Long Olympic Sleeve (#57) onto the Right side of the Bar. Secure it with

a M8 x 1/2” Allen Screw (#59). Repeat the procedure for the other side. Attach

two ∅2” Spring Clips (#34) onto the Olympic Sleeves. Note: If you are using

standard plates, remove the Sleeves.

F.) Attach the Front Top Beam (#19) to the top of the Front Vertical Beams (#9) and

Guide Rods (#16). Secure the Guide Rods with two M8 x 3/8” Allen Screws (#60)

(The screws should be already on the circular clamps.)

G.) Secure each side of the Front Top Beam (#19) with two M10 x 2 ¾” Carriage Bolts

(#11), ∅ ¾” Washers (#5), and M10 Aircraft Nuts (#6). Securely tighten all the

nuts and bolts previously installed.

1 2 3 4 5 6 7 8 9 10 11 ... 22 23

Keine Kommentare

Impex SM-3000 Bedienungshandbuch Seite 6